Matching sports spring with stock absorbers ...appreciate feedback

[marv3]

I think the ground is pretty even. I cant tell if the front is elevated though. Looks level to me. Hahahaha. Eye problem. So review still on??? Hahahahaha!!!

 

[Izso]

What review? Remind me again?

 

[marv3]

What review? Remind me again?

Ooooppppssss....My bad...Thought it was you who joked about the review in previous page...But is actually gunerzzzz who mentioned it....Hahahahaha....

Now that i've done my springs....Wonder what next project to do??? Hmmmmm

 

[beatnik]

looks lowered already.. you should have measured the height from centre rim hub to the fender edge, before and after.. this way you will know how much the springs lower your car.

from the picture, the rear looks lower than front.. but this is probably due to the original setup is already like that:
http://116.12.55.24/my/wp-content/uploads/2012/05/Pug-408-web-4.jpg

 

[marv3]

looks lowered already.. you should have measured the height from centre rim hub to the fender edge, before and after.. this way you will know how much the springs lower your car.

from the picture, the rear looks lower than front.. but this is probably due to the original setup is already like that:
http://116.12.55.24/my/wp-content/uploads/2012/05/Pug-408-web-4.jpg

Yah man....Kind of regret never measure. Was kinda excited about getting it done, and forgotten to measure it before the springs.

Yes you are right. The rear wheel gap, even before springs, has been smaller compared to the front. I think ori setup is like that. But from the pics, i think it has lowered. But by how much i dont know. Looks better now coz the front wheel gap is not mogo huge anymore. About 5cm-6cm from the rubbers.

But the ride has definitely stiffen and the handling is better now. The road feedback to steering is much better now. Loving it.....

Looking at what to do next......Downpipe perhaps??? Hahahahha

 

[Izso]

It's a turbo?

Depends on your budget. But you'll need a new thread already since this is specifically talking about matching springs with abs.

 

[marv3]

So i just start a new thread called "Modding 408 Turbo"???

Thank you guys so much for all your comments and advise......

 

[gunnerzz]

So i just start a new thread called "Modding 408 Turbo"???

Thank you guys so much for all your comments and advise......

time to get a piggyback ecu to release a bit more horses.
my firend is using the 508 turbo and the engine does not feels like a turbo unit.
it smooth and very powerful indeed.
so,u can imagine wht more horses will do rite?
just make sure u stay within the gearbox torque limitation.