Emanage Blue help

[flatlander525]

guys..

using emanage blue on mazda BPT 1.8 pressure reading from 3bar map by V

my problem is why WOT ( wide open throttle ) detect only 30%.?

previously done tuning but after overhauling my engine and still remain the same setup but my WOT now only detect 30%

how can this happened? and what will happen if i still remain thin 30% of WOT? and how the reading becomes in my EMB.

how to make it detect WOT 100% back?

need somebody troubleshoot this prob for me plz..

Thanks

 

[dneilmotorsports]

calibrate ur throthle setting...

 

[flatlander525]

so if i done that everything will be normal again?

 

[dneilmotorsports]

yup, open parameter setting on ur e-manage. then click throtle settup, calibrate it again.

 

[flatlander525]

ok thanks for the tips dude.

 

[xtremeleo]

if dat doesnt solve it, try feeding 5volt to the emanage tps wiring, see if it increases the reading to 100%. if it does, its either the tps power supply or the tps itself is fecked up. please check and report back

 

[flatlander525]

ok i just reset the WOT now detect 100 WOT but now idle WOT reading 30% ayakkk why?

engine must running only it can detect WOT if not cannot detect...

 

[dneilmotorsports]

in that case, u must recheck the wiring tapped at ur ecu, maybe u should change ur tps sensor. u just turn on the ignition and full press ur acclerate pedal and click O.K,that's all. No need to calib at the idle !!