[help]How to install Power Cap?

[yewnen]

[help]How to install 3 Terminals Power Cap?

Hi!

I'm Lau, newbie from Kuching, Sarawak. I bought a Power Cap (Pioneer 2.0F) and I'm facing one problem. Need sifu's advice and help.

unlike other power cap, there are 3 terminals on the capacitor unit as shown in the attachment. Where should I connect the AC to? :frown:

 

[cacin]

yours come with digital voltmeter right?
is the other one labeled AC or ACC?

 

[yewnen]

yours come with digital voltmeter right?
is the other one labeled AC or ACC?

Yup! It comes with the digital voltmeter display. There are 3 terminals, one with label AC, the other 2 no labels, only color red and black. :frown:

 

[howiechoo]

ac is the remote from ur HU, red is the direct from ur battery, black is the ground
rite?

 

[cacin]

caution

if AC is to be connected to remote turn on from the HU, please make sure you do not put to much strees on it. Like connecting it to other devices that needs remote turn on like amps, eq and active x-over. Try use a relay for this and make sure it is fused.

Hope this helps.

 

[yewnen]

if AC is to be connected to remote turn on from the HU, please make sure you do not put to much strees on it. Like connecting it to other devices that needs remote turn on like amps, eq and active x-over. Try use a relay for this and make sure it is fused.

Hope this helps.

So the AC terminal is connected to remote turn on from HU? if confirm, then i'll connected the remote to to trigger the relay to connect the battery voltage to AC terminal. OK?

 

[yewnen]

I have connected the AC terminal to the ignition/remote. It functioning satisfactory. Thanks a lot! :shakehand