any carb weber wana letgo ......pls pm me .....thanks ....
thinking to let it go, but still thinking bout it.. eheheheeee.. gona let u know if i cant manage to settle up my car..
any carb weber wana letgo ......pls pm me .....thanks ....
thinking to let it go, but still thinking bout it.. eheheheeee.. gona let u know if i cant manage to settle up my car..
Hi brothers out there
Thanks for highlighting so many things about carb. I am also a carb car owner but its a 4x4, Terrano. Its all original. Was thinking of adding K&N air filter to it but i could not find it. Nowadays they sell only the open pod or direct replacement but i am looking for the old type whereby there is a chrome cover that sits above the carb itself. Can any bro out there let me know where i can find such K&N air filter around klang valley.
Thanks brother for all yr help.
bros, mind to share.. what will happen to the carb if the engine havent been started almost 6 months? i just wonder..
Need held from any 4G91's 'otai' around here..
I've just installed my Iswara C21A with a 4g91 carb engine equipped with ECU & electronic carburetor. After installation, i'm happy to see my new engine's running at low temperature during the test run by my mechanic.. But after it reach higher temperature, the engine becomes problematic. When the fuel paddle stepped, the engine goes jerking like it short of fuel composite in its mixture. After my mechanics check thoroughly, there's something missing on the carb's wire. Its a bind of 3 green wire were being cut and left exposed. But my mechanic don't know what was missing.
Now i want to know what it is and where could i find this mysterious parts..
I hope some honorable otai in here could help me out.
wahhh 4g91 carbie....nice...
i'm no otai...but perhaps if u can snap the picture of where was the wire goes to...maybe we can have some guessing what was missing
Thanks ^pomen_GTR^,
these are the images i snap but not as clear as DSLR images. I hope these will help you to identify what 's the missing device.
1st image: the circle shows the exposed end of the green wires. Each wire got stripe colored black, red, and brown.
2nd image: the circle shows the position of where the wire goes.
3rd image: closer image to show the position
4th image: taken from different angle, from under the carburetor. it is so blurry. cant get a clear one coz it was a difficult angle to snap.. sorry..
Similar threads | |
---|---|