sanekit
1,500 RPM
Not much of a DIY tutorial. I just mod a 4 spoke mitsu steering wheel that has a bigger brass horn contact by adding old brass contact from my 3 spoke lancer steering which got cracks and sunburn. Used some copper conductive tape to stick them together. I do guitar repairs and the copper tape are use for ground shielding of the guitar wiring cavity. Hence I have bits and pieces in my workshop.
Here's the photo.
http://s7.postimg.org/4cadg8v4r/IMG_4829.jpg
The one sticking out is the old brass horn contact.
http://s14.postimg.org/ao0uggof5/IMG_4830.jpg
The brass pin now in contact with the old brass ring which is smaller in diameter.
http://s12.postimg.org/f7m802jod/IMG_4828.jpg
Tested the connection by touching the yellow wire to the steering shaft and it works!
http://s9.postimg.org/qhn2qxntb/IMG_4831.jpg
Loving the new steering wheel.
Here's the photo.
http://s7.postimg.org/4cadg8v4r/IMG_4829.jpg
The one sticking out is the old brass horn contact.
http://s14.postimg.org/ao0uggof5/IMG_4830.jpg
The brass pin now in contact with the old brass ring which is smaller in diameter.

http://s12.postimg.org/f7m802jod/IMG_4828.jpg
Tested the connection by touching the yellow wire to the steering shaft and it works!
http://s9.postimg.org/qhn2qxntb/IMG_4831.jpg
Loving the new steering wheel.