Racing Harness

[integramania]

Hi guys

Wondering where to mount the back belt of the racing harness? I know some ppl mount it to the rear strut bar bar if the thing too short to reach it how ah?

Tx

 

[EG9]

what kind of hardness that u're using? can just mout on original safety belt point.

 

[integramania]

where is this located...coz you need to mount the back portion to something that is directly behind it in a straight line...meaning like a loop of some sort...by the way its a Sabelt...only if it was longer than ok ler I can attach it to my rear strut bar

 

[sta]

i have seen b4, a wira mounted to the rear bar inside the boot.
but not practical because then ppl cannont sit in the back seat.

i think u can fix a room bar in the rear passenger footwell and attach the harness to it.

 

[whatdamn]

integramania,
locate the seat belt buckle points under the rear passanger seat. there should be 5 or 6. these threaded holes are where you should bolt the eyebolts provided with ur harness. recommended is always a criss cross placement of the harness (ie. one overlapping the other to form an 'X').

 

[V-Spec]

Aren't harness supposed to be mounted in a 45 degrees angle.

 

[integramania]

Hi guys,

I did try to look for any places under the rear seats to mount but couldnt find any...a fren told me I need to weld "hooks" to get it down

 

[Dremel]

Adrian.. harness for your dc2 recaro? ;D

Guys.. any idea where to get eyebolts?

 

[khoyos]

Guys.. any idea where to get eyebolts?

as the name suggested, u can get it from nut n bolt shop. cost rm2.50 each. u need 4 (2 for sides, 2 for the back). there's a nut n bolt shop in padang jawa, klang.

 

[Dremel]

Actually, I went to a few nut/bolt shop but most of the eyebolts don't match since the sleeving is different.

Anyway.. Thanks for the input. I'll try to look for it at the place you've mentioned.

 

[khoyos]

easy. buy a nut that fits the eyebolt. weld the nut to ur floor. then u can fasten the eyebolt to the nut. a nut cost 20cent only hehehe

 

[integramania]

Dremel....hello bro....now using Bride full bucket for a change....bloody hard to get in and out....

Sorry ah can anyone post a pic of this eye bolt... can't seem to picture it

just a round looking thing that can allow the clip to fit in?

 

[Dremel]

yes it is

​

 

[integramania]

thanks bro...so its called a eyebolt rite.....haha....hope the bolt uncle will know when asked