can b18cr head intall in b16a block ??

[eater_eg6]

any diffrent wif the b16b head n b18cr head ??? can rojak wif the b16a ??? gona moddify anything ??? thanx.. :)

 

[xerofighter]

b16b has higher lift cams then b18cr on the intake side. exhaust i think its the same.

 

[SiGNAL]

Other than that, the ports on the b18cr should be slighty bigger cause of the larger displacement. But i'm not sure. :P

 

[harpoon]

bro,

that rojak thing can aways be done.
ppl even put b16a or b18c head mated to b20 bottom,
b16a has a shorter stroke compared to b18c.

b16a bore n stroke: 81 X 77.4 mm
b18c : 81 X 87.2 mm
so the piston size is the same, only a lil diff on conrod length.

block height differ by 7mm

there's a page at honda-tech that gives all info bout dimensions
of both engines, from there you can compare n figure out what u
need to do

or else u can check it out at

http://www.import-dr.com/table1.html

 

[harpoon]

little mistake there, b16a n b16b same b&s, my typo error

 

[danieL]

b16b has higher lift cams then b18cr on the intake side. exhaust i think its the same.

you are right, but its only 2 degrees lerr, put one adjustable cam pulley kau tim...........

 

[danieL]

any diffrent wif the b16b head n b18cr head ??? can rojak wif the b16a ??? gona moddify anything ??? thanx.. :)

you can put with a b16a block, no problem..........
but since u already have such a nice head, put b20 block lah....... !! heehhe

 

[xerofighter]

you are right, but its only 2 degrees lerr, put one adjustable cam pulley kau tim...........

i didnt know adjustable pulleys can raise cam angle :p. i thought it was used to fine tune the engine only.

 

[danieL]

oops my mistake then..
what i am trying to say is that a lot of ppl think the b16b cams is better than b18cr cams......true to a certain extent lah, 2 degrees
but u can push the b18cr cams to make it as "good" as the b16b....

 

[aramis]

oops my mistake then..
what i am trying to say is that a lot of ppl think the b16b cams is better than b18cr cams......true to a certain extent lah, 2 degrees
but u can push the b18cr cams to make it as "good" as the b16b....

I thought 3 degrees? :p

 

[danieL]

not 2 meh....
but u are the sifu here.........you should know better right? hehehe

 

[aramis]

haa..haa...sifu? :P

http://www.g-speed.com/pbh/b16a/

 

[danieL]

aramis sifu has spoken....

 

[hattech-v]

b16b cams better than b18cr? why aaaa?

 

[BlueG]

aramis sifu has spoken....

Yup, he is the sifus .. hehehe ...