juz wanna share my "holiday-nothin-better-to-do-project"...
items needed:
- drill - with 2mm drill bit
- acrylic (plexi board) [those material for number plate's PLATE] - 3mm thick
- acrylic cutter
- file - semi round face
- stationary set
- hex saw
> get the plate measured, n cut to desired size using the acrylic cutter
> measure the distance for each meter n draw a 53mm circle.. not 52mm
> then drill the holes leaving few gaps around the circle
> after that use the hex saw...
Ask a question, start a discussion or post something for sale!
