Opti-Coat™Pro : Vellfire

s1tl

1,000 RPM
Senior Member
Jul 13, 2010
1,237
1,019
713
Ipoh/KL

This would be the 3rd car this client had us worked on. Toyota Vellfire but brand new! This is what we had always advised our clients to do, "Protection before it too late". Not wasting time further, check out our process.

Upon arrival, the car was already looking sleek and shiny.

The ODO had only recorded less than 200km, Hence the condition is near mint.

We checked the paint and found some light damages.

Some light haziness on the chrome.

Some light watermark issues on the chrome as well.

and also on the some sections of the paint where water usually flows through.

On the LED spotlight we found some visible swirls.

On the LED check light, those swirls became even more obvious.

Swirls on a nearby area.


After some paint correction, the surface is restored.

Moving the LED to a nearby region for clearer view.

Damage had been fully corrected.


Because the car was already in a rather good condition, no major paint restoration was required. We clean up and correction only damaged parts and applied the Opti-Coat™Pro as a finishing. Check out the unedited finish.


[caption align=alignnone" width=627] sdr[/caption]

 

Random Post Every 5 Minutes

sifu
i had changed my wira se cat con n center box to bullet
the set up like below:
ori wise 4-2-1 -> bullet -> 1.7' piping -> ori wise muffer
but i face a big problem after install
my car feel heavier than original set up
my fren changed his wise piping also
his set up is:
ori wise 4-2-1 -> 1.7' piping -> bullet -> 1.7' piping -> ori wise muffer
his car is more powerful after changed
may i know which setting is correct and suitable for my wira se manual :confused:
please help. ..
Ask a question, start a discussion or post something for sale!
Post thread

Online now

Enjoying Zerotohundred?

Log-in for an ad-less experience