Where to custom piston and con rods

[yewly1990]

Should try a single thicker gasket rather then two pieces.
If you custom make, then can boost even higher.....

Need to look for place to custom =I

 

[speed2horizon]

Combine metal gasket lor. Each metal gasket consist of multiple layers. Top and bottom are seal gaskets, the thick layers are space gaskets. The super thin one is compression gasket.

Remove the top and bottom layer of one gasket, slit in the remaining gaskets into another gaskets.

There u go. A custom thickness gasket.

 

[yewly1990]

Combine metal gasket lor. Each metal gasket consist of multiple layers. Top and bottom are seal gaskets, the thick layers are space gaskets. The super thin one is compression gasket.

Remove the top and bottom layer of one gasket, slit in the remaining gaskets into another gaskets.

There u go. A custom thickness gasket.

But actually how do I know how thick I should go?

 

[speed2horizon]

I do remember uploading an equation here for metal gasket thickness and compression ratio. But i forgot which century ago... lolx.

 

[yewly1990]

I do remember uploading an equation here for metal gasket thickness and compression ratio. But i forgot which century ago... lolx.

Too bad <3..... I try seek help with my brother google, see how does it help.

 

[KeeSeong]

Mine also BOT on crz... stock internal running 0.7 bar...also feel wanna change piston scare over boosting when up genting.. hehe always look at the water n oil temp gauge.. scare up.. hahaha

But bros said no problem wif low boost i reli hope no problem.. haha