Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="SataniC" data-source="post: 203161" data-attributes="member: 1094">ok i cannot really remember who i wire them up last time cos i fit them in with the guide of my mech....first...i tapped the original ignition coil with a suitable normal wire and pull them into the cabin....then i put my three way switch right at the steering column at the dashboard and put a fuse just in case....then continue pulling the wires from the switch to the truck where i had earlier installed an extra ignition coil at the trunk underneath the spare tyre...most cars got a premade hole covered by a rubber squeege...the spark plug cable run thru there to the exhaust...and screw the ignition coil to the car's body...this also act as a grounding....so basically....when the switch is flipped onto position 1(see pics) the car will run normally....original ignition coil is firing and the secondary ignition coil is stationary....when i flipped it to the 2nd position(centre) the primary ignition coil shut off(this is where we can enuff unburnt fuel for flaming exhaust) and finally when i flipped the switch to position 3....the secondary ignition will then use the power that was meant for primary ignition coil and fires the single spark plug placed right behind the exhaust muffler....so when im driving the switch is a 1...when wanna play i just straight flip to 2...press the accelerator down and flipped to 3....easy for manual cars cos manual car dies off much slower compared to auto cars....and when u feel that ur car is gonna die(check see RPM laa...if the needle going near 1000 then flip the switch back to 1....and the car goes back to life....and u dun need to put the car to neutral...just remember to take ur foot off the gas before u switch to 1 or else ur car will jump...AHHAHAHAHAH....but the problem is...i forgot how i rewire to tap the power from the primary ignition coil to the secondary igntion coil...its been a long time since i did this DIY...costed me roughly ard RM80...http://img.photobucket.com/albums/v370/patayalama/switch.jpg30 - welding spark plug20 - ignition coil0 - spark plug0 - spark plug cable10 - wires20 - aircon nut/screwnuts/screw is the hard one to find...i buy an aircon's part that can fit in the plug and cut in to enuff length so that the spark plug head is exposed.....</blockquote>

Verification

The Marketplace Latest

HONDA CIVIC FL5 TYPE R 2.0 (M) 2025
- Started by rickyteoh2288
- Cars for sale
TOYOTA GR YARIS 1.6 (M) 2025 RZ High Performance
- Started by rickyteoh2288
- Cars for sale
HONDA CIVIC FL5 MUGEN PART 2024
- Started by rickyteoh2288
- Cars for sale
original rare Enkei ES Tarmac 15x7jj offset +35 4H...
- Started by david tao
- Chassis and Wheels
original rare Rays Volk Racing SE37 17x7.5jj offset...
- Started by david tao
- Chassis and Wheels
original rare Yokohama ADVAN Racing TC4 18x8.5...
- Started by david tao
- Chassis and Wheels
original rare Rays Volk Racing ZE40 17x9jj offset...
- Started by david tao
- Chassis and Wheels
original rare Rays Volk Racing INGS TS06 18x8jj...
- Started by david tao
- Chassis and Wheels
New original Defi Advance A1 NA package triple...
- Started by david tao
- Engine and Performance
original rare Rays Volk Racing CE28 16x7jj offset...
- Started by david tao
- Chassis and Wheels

Posts refresh every 5 minutes

Lf rays wheels??

Hi All,

Everyone knows where to get those RAYS Wheels.

Just in case the particular ones you like isn't in stock with the Dealers in your area, we'll be able to assist.

Genuine RAYS Wheels from Japan.
We'll be able...

gtr r34 replica

There are a few R34 gtr replicas around, but with full engine conversion and some even with rear diff and 4wd done.

what do you think?

they are less than half price compared to gtr...it's recession now laarrr :D...

is it safe? (open pod)

my hks open pod green type filter already rosak. since i dont have money now to buy a new filter, is it safe for me to replace it with sponge? just for a couple of days.