Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="Wilson13B" data-source="post: 1063661709" data-attributes="member: 107613">Thanks for the advice ~Btw,what is Ported Shroud Housing?Any picture to show that?If the fin bent/touching the housing will it effect the boost pressure?,because the boost pressure still runs great....and i use my finger to try moving the fins between up,down,left,right and the fins doesn't even move a little,just stay hard there ~ so i think it's not that problem =S</blockquote>

Verification

The Marketplace Latest

Proton Preve R3 body kit
- Started by jeff6126
- Exterior and Body
Perodua Ativa gear up body kit
- Started by jeff6126
- Exterior and Body
BMW F10 Mperformance front skirt lip
- Started by jeff6126
- Exterior and Body
Honda Civic FC fk7si front bumper set
- Started by jeff6126
- Exterior and Body
brake caliper spray
- Started by jeff6126
- Exterior and Body
BMW F30 M3 bodykit/diffuser set
- Started by jeff6126
- Exterior and Body
Perodua Axia Rahmah bodykit
- Started by jeff6126
- Exterior and Body
Nissan Almera Tomei body kit
- Started by jeff6126
- Exterior and Body
original rare Black Racing Pro N1 16x6.5jj offset...
- Started by david tao
- Chassis and Wheels
original rare Rays Volk Racing TE37SL Black Edition...
- Started by david tao
- Chassis and Wheels

Posts refresh every 5 minutes

2008 Toyota Supra V10 , 2008 Celica

we have seen the V10 concept lexus pictures, which everyone assumed was the SUPRA, but this pictures are closer to the earlier "aston" styling concept pictures that appeared from japan.

LEXUS V10...

* * * 6 Signal Lighting * * *

Hie all tai kor & Sifu..! Is it possible we can D.I.Y the Signal Light all 'ON' at night? Can any SIFU teach us how to instal and set a Switch for it? Thx!
:)

CheerzZ!
:[ KK ]

Diy : Air Twister - Swirl The Air !

http://www.angelfire.com/crazy2/diy/airtwister.jpg

Why spin the air ? Spinning air provide a faster and cooler flow into your RAM pipe and Air Intake.

Steps.
1. Remove the fan
2. Cut off the middle part of the...