Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="cacin" data-source="post: 2466102" data-attributes="member: 10222">Like Zenn mentioned, running active give more options.When I say I assume you're running passive is you're using the passive crossover from your comp set.So, HU front out connect to 4ch amp. then the amp is bridged to power your front comp. The sub connection from HU go to sub amp.Running active would mean a setup like this:HU to electronic crossover.Highpass to 2 channel of the 4 channel amp which then go to tweeters.Bandpass to other 2 channel of the 4 ch amp then go to your midbass.lowpass to the sub amplifier.If your HU already have this capability (highpass, bandpass & lowpass), then you might not need an electronic crossover.</blockquote>

Verification

The Marketplace Latest

original rare Rays Volk Racing CE28 16x7jj offset...
- Started by david tao
- Chassis and Wheels
Honda Jazz/Fit JSracing GTwing Spoiler
- Started by jeff6126
- Exterior and Body
Toyota Vios NCP93 front bonnet hood
- Started by jeff6126
- Exterior and Body
Honda civic fc varis spoiler
- Started by jeff6126
- Exterior and Body
BMW F10 Msport front bumper set
- Started by jeff6126
- Exterior and Body
BMW F30 M3/GTS front bonnet hood
- Started by jeff6126
- Exterior and Body
BMW F10 vorsteiner rear bumper diffuser
- Started by jeff6126
- Exterior and Body
Mitsubishi Lancer Evo bodykit
- Started by jeff6126
- Exterior and Body
BMW F30 M3 front skirt lip
- Started by jeff6126
- Exterior and Body
Honda Civic FC fk7si front bumper set
- Started by jeff6126
- Exterior and Body

Posts refresh every 5 minutes

How to install a grounding cable kit - DIY style

Good day guyz,

actually, this is a simple DIY that anybody can figure out & do it by themselves..

i post this thread out of my 'bored'ness .. hehe

so, plz bare with me :biggrin:

p/s : if u have any...

Base Map - E6X

Need help from experience haltech user. Currently installed E6X 2nd hand to my VR4RS. I need to get hold base map for VR4 in order to tune it. I've been searching all over the net and even emailed to haltech directly...

Waja 4g18 hood change to CPS hood

anyone did this before?..changing the old waja hood to the new version?..can it fit?...what about the grill?..

any suggestion for the mod?...im a newbie with waja..so dont really know much bout it.

thnx