Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="AlucarD" data-source="post: 1063972233" data-attributes="member: 1703">Nowadays there are some performance thrust bearing and billet wheel that will make a 20G seems like a small fin as compared to a few years ago. I have a 20G billet wheel for sale. It will fit the EVO 1-3 turbos and it super light. I would even dare say lighter than the stock 16G wheel. PM me if any of you are interested. The big 22G wheel will out flow the small compressor housing and when too much air is flowing and you lift the throttle, the air will flow back to the compressor. This back pressure will cause your compressor fins to stall or even break your shafts. This surge of air is called compressor surge. A bigger housing will be better in preventing this or a ported housing with an anti surge cover.Thong can do all of the above to prevent surge which is very important for a mismatch or frenken wheel combo like what you are going for. Porting the housings is completely safe if the builder knows what he/she is doing. Go to Firdaus/bebolagas he knows what he is doing and can build you a turbo based on your specification and targets. Normally, these kind of turbo aka 20G, 22G, 25G. Will like higher boost to come into their operating efficiency. Something like 1.3bar and above will be good. No point running them in low boost.. So for a 4G93T you should have some intermediate mods like fuel, exhaust, bigger inter cooler pipings and intercooler and a good boost controller. A piggyback or Standalone ECU is in my opinion preferred as well.End of the day what are your plans? Budget, Power goals, Response requirement, type of racing or driving that you do. That should dictate what type or turbo mods or turbo that you want.</blockquote>

Verification

The Marketplace Latest

New original Defi Advance A1 NA package triple...
- Started by david tao
- Engine and Performance
original rare Rays Volk Racing CE28 16x7jj offset...
- Started by david tao
- Chassis and Wheels
Honda Jazz/Fit JSracing GTwing Spoiler
- Started by jeff6126
- Exterior and Body
Toyota Vios NCP93 front bonnet hood
- Started by jeff6126
- Exterior and Body
Honda civic fc varis spoiler
- Started by jeff6126
- Exterior and Body
BMW F10 Msport front bumper set
- Started by jeff6126
- Exterior and Body
BMW F30 M3/GTS front bonnet hood
- Started by jeff6126
- Exterior and Body
BMW F10 vorsteiner rear bumper diffuser
- Started by jeff6126
- Exterior and Body
Mitsubishi Lancer Evo bodykit
- Started by jeff6126
- Exterior and Body
BMW F30 M3 front skirt lip
- Started by jeff6126
- Exterior and Body

Posts refresh every 5 minutes

Worth To Buy This Car Or Not

I am Interesting This car since i am newbie so would like u all give me a suggestion thx alot GTR power curve-page-1 (1).pdf 490.41K 18 downloads
Nissan Skyline GTR35

This car totally service at ST Wangan KL...

The end of car washes!

Screw Plastidip, I want this!

Ultra Ever Dry - YouTube

Imagine never having to ever wash your car again. All you need to do is air blow clean your car cuz nothing...

Japan 17inch WORK EUROLINE for sales

sold...............................