Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="edgar_raphael" data-source="post: 293732" data-attributes="member: 463">few tips.1. For original panels that has rough surfaces, such as the plastic panels from the Proton cars, it will be advisable to sand the surface with the lower grit sand paper to as flat and smooth as possible, then slowly increasing the grit number to a higher one to get a smooth flat surface. That way, the quality of the paint would be better.2. Before spraying, take a pail, fill them with hot water, but not boiling hot water, just a little warmer water, put all your spray cans into the pail, this way would increase the air pressure from inside the spray cans and will result in a better efficient in the nozzle, and also the spray air coming out3. When using spray can, always remember to place the item to be painted as high as possible near your hand level so that when you spray, it would be high as your waist line and you dont have to face the nozzle that low, spray with the nozzle facing around 30-40 degrees down, that way you get the best effect.4. lastly, patient must be there, spray as thin as possible, one coating by one coating, and leaving them to dry around 5-8 minutes per coatings before continuing. The more thin coatings you can apply, the better and thicker and nice the end results will be. We cannot use the technique used in normal car sparying because they used pressurised air and the paint material is different and they even mixed them with thinner, and better nozzle tips, thats why they can spray more and less coating but still getting good results.hope this helps.</blockquote>

Verification

The Marketplace Latest

original rare spec Rays Volk Racing RE30 15x7jj...
- Started by david tao
- Chassis and Wheels
original rare Rays Volk Racing TE37 SAGA S-Plus...
- Started by david tao
- Chassis and Wheels
original Swift Springs rear strut bar set made in...
- Started by david tao
- Chassis and Wheels
Proton Preve R3 body kit
- Started by jeff6126
- Exterior and Body
Perodua Ativa gear up body kit
- Started by jeff6126
- Exterior and Body
BMW F10 Mperformance front skirt lip
- Started by jeff6126
- Exterior and Body
Honda Civic FC fk7si front bumper set
- Started by jeff6126
- Exterior and Body
brake caliper spray
- Started by jeff6126
- Exterior and Body
BMW F30 M3 bodykit/diffuser set
- Started by jeff6126
- Exterior and Body
Perodua Axia Rahmah bodykit
- Started by jeff6126
- Exterior and Body

Posts refresh every 5 minutes

Recommended tyre pressure

Hi guys,

Anyone happen to know the recommended tyre pressure for a 215/45 R17 tyre?

Thanks in advance.

Singapore Paul's Wedding

Paul's wedding dinner coming up just round the corner.Brothers from KL, whose's coming down?

Engine Problems ? HELP!

Hi guys,

I need help with my FD. Got this wierd problem. On cruising and occasional flooring the car is fine. But when i go drag racing, the 1st 4 gears are fine, but when i upshift to 5th the rpm can't climb. It...