Looking for: BCNR-33 Fronts Camber Arms

http://i153.photobucket.com/albums/s216/iexit/byaihs-img600x450-12436490747bajm66.jpg

eyong, yup they just make the lower arms and the rear arms...BAH! nvm keep looking... its on my halfcut to do list :-)


Woit .... Where did you get the photo from :hmmmm: Up for sale, or you just teasing me with it :mad:

Actually, to fabricate an adjuster to the oem front upper arms is not too difficult ... Just have to get the spacing right, and make sure you don't cut off too much material which may compromise the strength, as the oem are just pressed steel. It will probably work pretty much the same as the cusco's minus the lansi-ness effect only ... :biggrin:
 
plenty in japan auction. But will cost about 800-1000 after shipping... plus its used $@%#^&. See lah if i really cannot find i'll make one, should be a good DIY project
 
plenty in japan auction. But will cost about 800-1000 after shipping... plus its used $@%#^&. See lah if i really cannot find i'll make one, should be a good DIY project


I think that's the price range ... Unless someone in here, or some chop-shop has and willing to sell ... I thought about modifying the oem too, it should work but spend some time think of where to effectively strengthen ... Fully support the experiment :adore:

I have seen other two separate arm design and quite cheap too but query about the rotation of individual arm during heavy loading :hmmmm:






By the way, Malaysia Boleh DIY ... Waaaaaa Ahahahahaha HAHAHAHAHAHA ... :biggrin::biggrin::biggrin:



http://nismoclub.6.forumer.com/a/how-to-make-ur-own-adj-camber_post15471.html
 
Last edited:
Dang .... Missed out on a pair of Cusco arms yesterday .... Stupid undecisive mind of mine :mad:
 

Similar threads

Posts refresh every 5 minutes




Search

Online now

Enjoying Zerotohundred?

Log-in for an ad-less experience