How much tufoil to use?

[zambri81]

i have just recently change my engine oil, about 1000 km since i change it, is it ok for me to add tuf oil now???????? my car a wira 1.5 carb is one bottle enough?????

thanks

 

[FocalPoint]

At 1,000 km into the new oil change, the engine oil is still quite clean. It is O.K. to add in Tufoil.Your car uses one 8 oz. bottle.

Thanks zambri81 for the support.

 

[silverwave]

for first time user, use 1 full bottle right? second time half the bottle right? but after how many km should i add the tufoil again? normally i service my engine each 10k km. when i service i add 1 full bottle of X-1R.

i'm also going to change my engine oil next service.

currently i'm using X-1R and castrol magnetec.

so, what is the best scale to use the tufoil? how many km per bottle?

 

[FocalPoint]

One full 8 oz. bottle of Tufoil will be needed for an engine that uses 4 - 5 litres of engine oil.On subsequent oil change, a minimum of half a bottle is usually good enough.

Some people change their engine oil at 10,000 km. Others, 5000 or 7000 km. For our own cars, we have maintained a 5000 km change interval regime since 20 over years ago regardless of the kind of motor oils we use.

 

[BV5015]

hmm...
1st time full bottle
follow by half bottle per maintainence...
so, will be a lose for the mineral oil user? coz they service for 5000km...
full synetic is the most suitable oil ?

70's old junk can use it?

 

[FocalPoint]

Some cars may be old but the engine compression, rings and cylinders may be in good condition. It is O.K. to use Tufoil. But one should check the oil dipstick level once a while. In cases where rings are really bad or cylinders are badly scoured, oil consumption may be greater.In such cases normally a thicker oil like a 20W may help to lessen the oil loss.

 

[BV5015]

hmm..
normally old enjin need more sticky enjin oil to protect it...but Tufoil will solid it.....make sense?

webber enjin also can?

 

[FocalPoint]

Webbers are rev-happy kind of thing. Tufoil will quiet down engine considerably and give you the silence to balance the carbs and turn the mixture screws one at a time to give the best engine tick-over.

 

[BV5015]

than the amount to pour in need very careful neh.... :p