Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="Shamanraj" data-source="post: 1528235" data-attributes="member: 28579">Here is what has been done. When fan is turned of if rotates based on your carb air intake. Sometimes you turn it on when you are at low rpm. Am i right? If yes, then you have 2 prob.1. High RPM, where ur fan just turns based on low preasure created by carb, ur fans are restricting air flow....if ur fan was stationary, it would be better cause it will induce air swirl which is good for combustion.2. At low RPM when you turn on ur fans, yes you are pushing in more air than ur carb needs....but there is no point in this. You need to always make sure that your stoichiometric air & fuel ratio is met....14.7:1 ratio. Anything lower than this is rich mixture and anything higher than this is lean mixture. There is another theory saying that if your oxigen sensor is working fine, than the fuel will be adjusted properly as in this setup of yours it will detect excesive O2 in ur exhaust and decide that your engine is running lean and adjust the fuel to meet the stoichiometric value....hence increasing power abit.my 2 cents.</blockquote>

Verification

The Marketplace Latest

New original Defi Advance A1 NA package triple...
- Started by david tao
- Engine and Performance
original rare Rays Volk Racing CE28 16x7jj offset...
- Started by david tao
- Chassis and Wheels
Honda Jazz/Fit JSracing GTwing Spoiler
- Started by jeff6126
- Exterior and Body
Toyota Vios NCP93 front bonnet hood
- Started by jeff6126
- Exterior and Body
Honda civic fc varis spoiler
- Started by jeff6126
- Exterior and Body
BMW F10 Msport front bumper set
- Started by jeff6126
- Exterior and Body
BMW F30 M3/GTS front bonnet hood
- Started by jeff6126
- Exterior and Body
BMW F10 vorsteiner rear bumper diffuser
- Started by jeff6126
- Exterior and Body
Mitsubishi Lancer Evo bodykit
- Started by jeff6126
- Exterior and Body
BMW F30 M3 front skirt lip
- Started by jeff6126
- Exterior and Body

Posts refresh every 5 minutes

R34 engine swap labour cost

Hi friends.

I plan to have my R34 GT-X convert to R33 RB26DETT with R33 5-speed manual transmission on January 2010.

Heard a lot of talk about the labour cost. Some people says in KL they do it for less than...

Original 5Zigen with full Apex'i stainless steel piping for Evo 7 above for sale!!!

Selling off 5zigen inlett 3" exhaust system with 3" Original 3" Apex'i stainless steel piping for Evo 7,8 & 9 including Original Apex'i Downpipe

Previously Taken off from Evo 7 CT9A at JFA Condition cun ( in pics...

Tokyo Auto Salon 2006 - Part 4 | Exclusive Coverage