Reply to thread

Message: <blockquote data-quote="ericlo" data-source="post: 1268708" data-attributes="member: 7066">so sifu zenn and sifu oldskolboy. basically is 1. start everythin by 02. turn the HU volume to its max distortion and slightly turn lower volume( and thats the max volume that i can go with my HU)3. and then start with both the amp gain and xover gain till its max and lower the gain a bit to avoid distortion. (and thats the max gain setting for both amps and xover) 1 question here, do i touch with amp GAIN 1st then xover GAIN or xover GAIN 1st then only amp GAIN? or both at a time?4. the 4ch ADX amp if possible i bridge them to 2ch for higher output power. set the amp to full/fullpass/flat. and the xover at amp put it at minimum.5. the sub i wired them at 4ohm parallel, and bridge the kicker amp to 4ohm load for the sub.6. at the x3i elec xover, high pass i set it at 100hz and slowly turn down to max 65hz for adjustment (depending onto the freq respose by the component set) ! question here, how would i know how must of freq response can my driver goes? by listening to the distortion or by reading the manual from my comp set?7. then the x31 elec xover low pass i set to 60hz and slowly turn down to 45hz for adjustment (depending onto the sub freq response) bass boost is up to my happy as to set at 0db, -6db, 6db, etc.did i put the steps right or if there are anythin lack can sifu help to correct me?thank u thank u</blockquote>

I shot these 2 nights ago... I am putting up the short run video first... later i'll post more... ;)

https://www.facebook.com/photo.php?v=10151035225617008

https://fbcdn-sphotos-a.akamaihd.net/hphotos-ak-snc7/426820_10151235468625324_828610323_22338733_43494460_n.jpg

Last Saturday, Race Craft Academy held an open trackday dubbed the Dragon Prosperity...

Spotted mloc!!

SPOTTED CANNONDALE BRO AT KEPONG 25/12 10.18PM NICE RICE U HV... :adore:

Log-in for an ad-less experience