Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="gunnerzz" data-source="post: 1064733666" data-attributes="member: 166532">Yes and no.All car have specific point at the pinch weld where u can jack and almost all cars are equipped with jack which have slot on the surface meeting the pinch weld like bro lsm 1991 said.Look closely at the spot u will notice there will be solid surface behind the pinch weld.In your case i believe it is caused by using the hydraulic jack which have the steel cup instead of a slotted top. To prevent damaged when using hydraulic jack some used thick rubber pad or a few piece of tire cut to fit the steel cup. I believe most car hoist have this to prevent damage, you can check those hoist to get better picture.On one of my car, the same damage can be found on the area at the front ( behind the front tires ) when i used hydraulic jack without using any additional material to prevent the damage. Funny as i did the same to the rear but no damage.Be very careful when jacking your car be it with the ori spare tire jack or hydraulic jack. Only jack at dedicated spot or spot which can take the load. How to know?Most of the time its logic. Also, the ground where u place your jack must be solid. I know a guy whom severed few fingers when the newly paved road sinks while the car is on hydraulic jack causing the front brake disc to scrape of meat of his fingers and permanently damaged a few.</blockquote>

Verification

The Marketplace Latest

original rare Rays Volk Racing TE37SL Black Edition...
- Started by david tao
- Chassis and Wheels
Honda city JSracing gtwing spoiler
- Started by jeff6126
- Exterior and Body
Honda civic fd ~car spray(Ferrari red)
- Started by jeff6126
- Exterior and Body
Honda jazz fit gk flrs body kit
- Started by jeff6126
- Exterior and Body
BMW F10 ~M5 front skirt lip with glossy black
- Started by jeff6126
- Exterior and Body
Kia Forte gtwing spoiler
- Started by jeff6126
- Exterior and Body
BMW F30 M3 front skirt lip
- Started by jeff6126
- Exterior and Body
Proton Saga VVT Evo Front Bonnet Hood
- Started by jeff6126
- Exterior and Body
Perodua bezza gear up body kit/spoiler
- Started by jeff6126
- Exterior and Body
BMW F10 ~M5 front bumper set ~M5 kidney grille...
- Started by jeff6126
- Exterior and Body

Posts refresh every 5 minutes

Gsr Rs lag/no power and response issues.

Hi Sifus,

I am using a GSR RS and recently my conrod bearings gave away.

I have changed all rods and bearings,the foreman also polished the crankshaft as the bearing mounts were kinda giving away.

I had also...

2011 Osaka Auto Messe Part 1 - Aftermarket madness