sure la V shape or flat shape cannot roll the fender using that device..
coz that device resting on the wheel hub..using it as center-point of the curve for that arch....if the arch was flat or v-shape how to roll using curve radius method??
how bout if i want to make it flare out instead of just flattening the inner side..
looking for someone who can roll & 'flare' (fender pulling) to accommodate wide rims
<iframe width="420" height="315" src="http://www.youtube.com/embed/oIVkBFC-RDo" frameborder="0" allowfullscreen></iframe>
---------- Post added at 06:54 PM ---------- 6 hour anti-bump limit - Previous post was at 06:45 PM ----------
another video here, "pulling" fenders with fender roller..
<iframe width="560" height="315" src="http://www.youtube.com/embed/qRBsHzSXkqY" frameborder="0" allowfullscreen></iframe>
most of those fender rollers in sunway only know how to flatten the inner fender from U shape to V shape only. can give clearance only by a few mm's..
still cant find anyone who can pull fenders with fender rollers in msia..