i have this set and keep for around 1 year edi...
anyone interested pls pm me ur offer...
bought it at RM1xx
Condition is brand new...
never open the plastic...
no time for start this project...
only 1 request...after completed pls snap some photos for me....
Hi bro, thanks...
Must find out how to disasseble the fog light, coz the "yellowish" is from inside... Anyone did it before?
If anyone get to know any available from any chop shop, please let me know. TQTQ.
i have a lots of loose item for sale from my front n rear cut especially the bodypart........version 4 rear spoiler + boot, front white lamp(signal+small lamp), fog lamps, version 1 rear xmember, 2pot brakes, n etc......
anyone interested can gimme a call......wanna clear some parts to cover my expenses n space to store.....012-2249991
tom`s... please quote me the set of signal+small lamp... also do you have side door triggering panel cover? ( inside 1 ) .. mine plastic cracked liao...
goober... you selling your half cut or just some parts?? i interested leh.. planning for a transplant... you may email me [email protected]. thanks.....
For sale 3S-GTE and SW20 parts:
-Ported& Polished head (rev happy :)
-Balanced Conrods (rev happy :)
-Balanced Crankshaft (rev happy :)
-Turbo 3S-GTE Gearbox
-Rev 3 (245) Injectors @ 550 cc
-CT26 Turbine with actuator
-CT20B Turbine with actuator - SOLD to Soff
-Oil Cooler from RX7 FC3S with adapter & bracket for SW20
-Bilstein Shockers with Eiback Springs (lower by 2")
-GT Wing (Taiwan)
Just recently i have just screwed up my engine. I'm using B20 block, B16 Head, Block guard, Wiseco 86mm (high Compression),and a Ngk spark plug. The Block are over heated without notice, the piston was ok still however the block has scratchs on the both side (not the inlet and exchaust) of the stoking path. at the bottom of the block the piston stroking area are warped and runs 1mm of the daimeter.
So Sifus, are they anyway to prevent that from happening again? Your advice is...
Ask a question, start a discussion or post something for sale!