Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="Lan Dugong" data-source="post: 1767354" data-attributes="member: 2152">B8t_ford,already replied in the plugs thread.:-<a href="http://www.zerotohundred.com/newforums/showthread.php?t=119808" target="_blank">http://www.zerotohundred.com/newforums/showthread.php?t=119808</a>here's the copy:-B8t_ford,this is what i have experienced.when i was with vj20 turbo, i've been running 35psi of fuel pressure at 1.2bar. No problem of fuel leaning out.playing with fuel pressure will experience in higher fuel consumption as fuel was not burnt fully and gone as wastage...this will also create carbon. but at the same time, u are actually running at a safe mod but lose of power due to rich mixture.imagine u are running at 42psi with 0.8b/1bar boost with vj20 or vj23 together with colder plugs....u will feel a little laggish.i know someone whose running a very big turbine in 180 but 30psi fuel pressure with the help of high flow fuel pumps & big injectors and he's running 1.5bar!u want good fuel pressure at high boost? upgrade your fuel pumps. this is actually the rule of thumb. without good fuel pumps, although u set to 50psi fuel pressure, what you get is high fuel consumption at low end but during higher rpm and higher boost, u might lean out due to fuel pressure drop. more over, your injectors suffer due to the high pressure.the best pressure of fuel? depends on your setup, your boost & your fuel pump. for me 35psi is good with vj20 1bar and below provided fuel pump upgraded to higher flow like walbro or rb25/rb26 etc etc</blockquote>

Verification

The Marketplace Latest

BMW F10 ~M5 front skirt lip with glossy black
- Started by jeff6126
- Exterior and Body
Kia Forte gtwing spoiler
- Started by jeff6126
- Exterior and Body
BMW F30 M3 front skirt lip
- Started by jeff6126
- Exterior and Body
Proton Saga VVT Evo Front Bonnet Hood
- Started by jeff6126
- Exterior and Body
Perodua bezza gear up body kit/spoiler
- Started by jeff6126
- Exterior and Body
BMW F10 ~M5 front bumper set ~M5 kidney grille...
- Started by jeff6126
- Exterior and Body
BMW f30 mad style front skirt lip
- Started by jeff6126
- Exterior and Body
brake caliper spray
- Started by jeff6126
- Exterior and Body
BMW F30 gts front bonnet hood with scoop
- Started by jeff6126
- Exterior and Body
Proton saga gtwing spoiler
- Started by jeff6126
- Exterior and Body

Posts refresh every 5 minutes

brembo caliper fitted

brembo caliper fitted and finished

Ok so i have installed rear brembo brakes just need to repaint them in blue ..
took about 1hr to figure out the best way of mounting them and 4 hrs to do the fabrication so...

Haltech Interceptor - Piggyback ECU

http://www.autojunctions.com/images/stories/prod/08/int/int1.jpg

Recently, i tried a product called Interceptor, it's a piggy back ECU from Haltech. Here's a brief write up on it...

Junk RX7 (FD3S) Wanted

I wnat to start my new project of building FD3S from scrach. I plan to use the car on the road and track.

I am looking for RX7 (FD3S) with NO engine. Or, RX7 with a screwed up engine.

So the ideal...