Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="edgar_raphael" data-source="post: 1452319" data-attributes="member: 463">Hi all, it was me who is the one from East Malaysia and claimed that it is easy to get access to fibreglass products in Sarawak as one of the members here had said.Anyway, it may be hard for you guys to obtain them in small quantity unlike in Sarawak, hence, what I would suggest is to 'group buy' , easy and cheaper when you guys are sharing all the cost.Not everyone is allergic to fibreglass, I am not :) I did everything with my bare hands with no protection gloves and clothes or whatever. It is not particularly harmful unless you cut yourself with the hardened matts or when doing the grinding because the debris and micro pieces of the cut fibreglass can attack/cut your skin when in contact and sharp enough to cause irritation. Please do not rub or scrub your hands or any body surface, but go straight to washing the debris away with soap and water and you will be fine, well that works for me.The ratio portion of hardener to mix in to the resin really depends on you, put less if you want a softer surface compound and longer period to completely harden the fibreglass, or mix in more, if you want a stiff hard surface compound which will fully harden up in a couple of hours, but the stiffer the surface compound, the easier it is to crack and losses its rigidity strength.Hope this little information helps, and for references, I attached my DIY Fibreglass Eyelids which I did, for like more than a year ago<a href="http://www.zerotohundred.com/newforums/showthread.php?t=19287" target="_blank">http://www.zerotohundred.com/newforums/showthread.php?t=19287</a>Any other questions, please direct here and I will assist you if I can, cheers.</blockquote>

Verification

The Marketplace Latest

original rare spec Rays Volk Racing RE30 15x7jj...
- Started by david tao
- Chassis and Wheels
original rare Rays Volk Racing TE37 SAGA S-Plus...
- Started by david tao
- Chassis and Wheels
original Swift Springs rear strut bar set made in...
- Started by david tao
- Chassis and Wheels
Proton Preve R3 body kit
- Started by jeff6126
- Exterior and Body
Perodua Ativa gear up body kit
- Started by jeff6126
- Exterior and Body
BMW F10 Mperformance front skirt lip
- Started by jeff6126
- Exterior and Body
Honda Civic FC fk7si front bumper set
- Started by jeff6126
- Exterior and Body
brake caliper spray
- Started by jeff6126
- Exterior and Body
BMW F30 M3 bodykit/diffuser set
- Started by jeff6126
- Exterior and Body
Perodua Axia Rahmah bodykit
- Started by jeff6126
- Exterior and Body

Posts refresh every 5 minutes

Wtb:FD ori 16" sport rim...

im looking for Rx-7 FD original 16" sport rim...
cause not money buy a new 1...
who got tis ori rim stock at home pls sell me...

RX7 FD Semi Buckets

Sold....................

boost cannot go higher.

hi guys,

recently when i drive my car i dont feel the kick summore.turn out to be the boost only is at 0.7bar.with the setting it is usually at 0.9 to 1.0bar.

what should i check 1st or do 1st to overcome this...