DIY – Perodua MYVI 1.3, Installing the Simota Replacement Air Filter

autocrazee

1,000 RPM
Senior Member
Joined
Mar 14, 2011
Messages
1,088
Points
1,638
Location
Kuala Lumpur
Replacing the stock air filters with an aftermarket version is the simplest way to improve your vehicles performance, longevity and economy. The Simota/Works Engineering Replacement Air Filters are quality built to high standards, plus improves performance and fuel consumption through rigorous research and development. Here, you will see the simple steps needed to replace your stock air filter with an aftermarket air filter for the Perodua MYVI 1.3. Other vehicles may not vary much in terms of installation.

We know this is pretty simple, but hey, never assume right.

Step 1

Find the right air filter and purchase. We at 12v.com.my carry a number of air filters for various makes and models. Get yours today!
http://audiotech.12v.com.my/wp-content/uploads/2011/04/PeroduaMYVI-RAF_01.jpg
Closer look at the Works Engineering Replacement Air Filter

Step 2

Open up your hood and get to work. Locate the air filter box and unclip the cover. There are six clips holding the box. With the cover off, you’ll see the stock air filter, begging to be replaced :)
Unclip these.

http://audiotech.12v.com.my/wp-content/uploads/2011/04/PeroduaMYVI-RAF_02.jpg
Unclip the six clips that hold the cover

http://audiotech.12v.com.my/wp-content/uploads/2011/04/PeroduaMYVI-RAF_03.jpg
The Stock Air Filter

Step 3

Take the stock air filter out and dispose of it. Put the new Simota/Works-Engineering Replacement Air Filter in it’s place. Make sure the right side is facing up.
Air Filter Comparison

http://audiotech.12v.com.my/wp-content/uploads/2011/04/PeroduaMYVI-RAF_04.jpg
Stock Air Filter and Simota/Works-Engineering Air Filter Comparison

http://audiotech.12v.com.my/wp-content/uploads/2011/04/PeroduaMYVI-RAF_05.jpg
Make sure to place the filter correctly

Step 4

Put the cover back onto the box, and reclip the 6 clips, and you’re done! Good Job!!! Take the car out for a spin now, you know you want too ;)

For more info, kindly visit http://www.12v.com.my/DIY-Perodua-MYVI-1.3-Installing-the-Simota-Replacement-Air-Filter/q?pid=520&doit=order

GOOD LUCK D.I.Y.ers'!!!
 
Hi,

For this installation, it's not going to be possible to do a review. Mainly because it's a showcar that isn't a daily driver and we don't really get access to do so at the moment.

We hope to do a proper review in the future, and when we do, rest assured we will post it here :)

Thanks for the interest tho.

Regards
 

Similar threads

Posts refresh every 5 minutes




Search

Online now

Enjoying Zerotohundred?

Log-in for an ad-less experience