extractor 4-1 and 4-2-1

[malster]

hye...
anybody can tell me whats the different between this 2 extractor..
and which one is better for satria 1.3m

 

[SkYwAlKeR]

ur car is an everyday car??...

get 4-2-1 extractor den...

if u are using ur car as trackday car... get 4-1 extractor..

 

[malster]

thanks for da info bro

 

[tiburonshrk]

4-2-1 are more intended for low revs and mid range. This helps during city driving or when u need just the right kick to overtake.

4-1 are designed for higher rpm range. I don't think this is appropriate as you don't usually rev ur engine that high most of the time.

Anyway, I don't think it is wise to change the extractor. A wrong design custom extractor will cause lots of problem to you such as loss of power. It is vital that an extractor measured and bent properly. If you still insist on changing, I would recommend hot bits extractor as I previously had on my satria and it was good.

 

[David_SGTi]

R3 way to go man!!!

 

[malster]

where can i find those r3 or hot bits extractor

 

[tiburonshrk]

For hot bits extractor, you can start with speedworks at jalan 222, PJ. They carry the whole range of hotbits products

 

[kennyyee75]

errr.... i dun think r3 is suitable for 1.3.......

 

[malster]

any1 noe where can find extractor yg murah2 punya

 

[afmarsyal]

wei yip wangsa maju atau seri kembangan..aku buat extractor kat diorang..4-2-1 downpipe swirl dalam rm280

 

[malster]

ooo murah gak..
kat seri kembangan tuh kat area mane

 

[fstr]

jian hang, extractor 1.3/1.5 RM 200 include installation.

 

[malster]

where is jian hang?

 

[tamok]

hallo guys
what about 4-4-1...lg power kot....cuma rege x leh tahan....

 

[SkYwAlKeR]

hallo guys
what about 4-4-1...lg power kot....cuma rege x leh tahan....

4-4-1??... exhaust header (banana) for turbo engine ahh??...