Reply to thread

guys, i fer one didn't mention anything of the thermostat to be totally useless, so i didn't advise anyone to remove it.


but i wanna drill out those holes to lower the engine temp by a tiny bit (my engine temp is always in the middle, a bit lower shud be better fer intake temp). i know there's a suitable operating temperature fer an engine to run, that's why i din remove the thermostat.


commenting on what engineer does, isn't fair at all.

cuz say engineers put boost cut @ 0.8bar fer safety, then why y'all gatal tangan wanna remove ha? :biggrin:


anyway we're on thermostat topic, i steer away frm off topic lor.:biggrin:


The Marketplace Latest

Posts refresh every 5 minutes

Cheap & Super Retarded way of DIY port and polish
Hey guys, I've got a 98 1.8T. I've had a k04 and chip for a while and wanted to get more performance. I was recommended to port and polish the intake and exhaust. We found out they used abrasive material to do...
Click to expand...
HKS F-Con iS on ER34. Worth it?
Saw some advert abt it. Looks good and preloaded for ER34 specs. Has built it Speed limit defencer and Rev limit defencer. It says that the item can be plug in to different car depending on the wiring harness. Cost...
Nissan SR20 NEOVVL use emanage ?
Hi zth members ,
Does anyone use this emanage in Nissan SR20 NEOVVL engine ?
Could some one give their opinion on it ?
Thinking of install a piggyback to control my fuel consumtion ......
Thanks....

Recent Posts

Search

Online now

Total: 2,429 (members: 0, guests: 2,429)

Enjoying Zerotohundred?

Log-in for an ad-less experience