Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="Izso" data-source="post: 1064650770" data-attributes="member: 2429">Going downhill at 100km/h? Wah.. big balls. Personally I think you should start with the basics, change the ATF oil and filter (use the proper spec oil, not D3 or D4 or whatever. If I'm not mistaken it uses SPIII so consider a good SPIII like Mitsubishi Diaqueen SPIII or something better. Then consider an ATF cooler. The Perdana has a fundamental weakness in its gearbox cooling design. Gearbox oil RM120+-, ATF filter RM80+- and halfcut ATF cooler RM100+-If all of this fails to solve the problem consider a well known additive like Lubeguard platinum. RM100 give or take for the additive.If even that fails to solve the problem then you'll need to consult a GB specialist and that'll be the most expensive option. RM1000++</blockquote>

Verification

The Marketplace Latest

original rare spec Rays Volk Racing RE30 15x7jj...
- Started by david tao
- Chassis and Wheels
original rare Rays Volk Racing TE37 SAGA S-Plus...
- Started by david tao
- Chassis and Wheels
original Swift Springs rear strut bar set made in...
- Started by david tao
- Chassis and Wheels
Proton Preve R3 body kit
- Started by jeff6126
- Exterior and Body
Perodua Ativa gear up body kit
- Started by jeff6126
- Exterior and Body
BMW F10 Mperformance front skirt lip
- Started by jeff6126
- Exterior and Body
Honda Civic FC fk7si front bumper set
- Started by jeff6126
- Exterior and Body
brake caliper spray
- Started by jeff6126
- Exterior and Body
BMW F30 M3 bodykit/diffuser set
- Started by jeff6126
- Exterior and Body
Perodua Axia Rahmah bodykit
- Started by jeff6126
- Exterior and Body

Posts refresh every 5 minutes

WTB an SA22C

Hi, I'm new to RE Club. Hopefully all big brother here can accept.

I recently planning to buy an SA22C with 13B turbo engine, but sadly the exterior and interior wasn't complete. So thinking to transplant front to...

how to built 2.2 stroker kit???

any one no how to built 2.2 stroker kit;
piston size???
conrod size???
crank size???
etc:

thanks

49178-01450 turbo compressor

ok guys, i bought this turbo from a guy and he claim it came from evo 3 halfcut, well it has been balance , clean and according to him it use a big 16g compressor.

But right now i'm a bit confused because from the...