Search results
-
pivot at-drive at shift controller
is it the one that we can change the transmission mode eg. eco, normal and sports mode?- reem1911
- Post #2
- Forum: Forced Induction & Engine Management
-
Introduction for New Member.
Hi. Just call me reem. I drove a 2006 Toyota Vios and still standard. I'm pleased to meet you all.. -
FS: Over 100 sets of Japanese Rims!!!
ongteckweng, can you please recommend any 15" rim, pcd 100 with price below RM2k? Do pm me the price and the model. Thanks and happy selling. :itsme:- reem1911
- Post #131
- Forum: Chassis and Wheels
-
Looking for TE37 17" ORI (4xpcd100/offset +40 above)
jack_does, i think if you search here, you can found a few te37 sets, mostly in white colours. Price ranging from RM2.5k to RM3.2k.. Happy searching.. :driver:- reem1911
- Post #2
- Forum: Chassis and Wheels
-
Vios '06 TRD Sportivo Spring
bro, how low is this spring compare to other lowering spring?- reem1911
- Post #9
- Forum: Chassis and Wheels
-
vios offset..
Standard offset for rim 15 is +45 with 5.5jj. Better to take offset above +39. Been using +38 but found out tyre will touch the rear fender. -
wat performance engine can fit into vios??
Bro, this item still available? You sell the absorber+spring separately? If yes, how much? Thanks. -
Seat Recaro Evo 3 n Evo 2 complete 10 set
Salam, Seat still available? How much if i want to buy only the front set? Either evo 3 or evo 2 seats. Thanks.- reem1911
- Post #7
- Forum: Interior and Cockpit
-
lots of rim for sell frm 10"~19" import frm Japan
Hi seller, Do you have SSR type X with size 15", 4x100, 6.5jj and offset +43? How much the price and where is your location? PLease PM me the details. sorry i'm still new here. Thanks..- reem1911
- Post #373
- Forum: Chassis and Wheels
The Marketplace Latest
-
20 rim with 2 tyre
- Started by astonmoo
- Chassis and Wheels
-
19 rim with 235/55/19 tyre
- Started by astonmoo
- Chassis and Wheels
Recent Posts
Random Post Every 5 Minutes
This simple circuit makes it posible to monitor the charging process to a higher level.
Final adjustsments are simple and the only thing needed is a digital voltmeter for the necessary accuracy.
Connect an input voltage of 12.65 volt between the positive and negative poles and adjust the 10K trimmer potentiometer until Led 10 lights up. Lower the voltage and in sequence all other Led's will light up. Check that Led 1...
Enjoying Zerotohundred?
Log-in for an ad-less experience