this amp betul ka? why the 1ohm power lower than the 2 ohm? should be opposite.
anyway if the sub is a dual 1ohm, then u need a monoblock that can go give u 900rms or more at either 1/2 ohm or 2ohm
Hey guys, recently I was comparing a few dyno charts and one of them had an AFR of 13.5 low end around 2k to 3k rpm. I'm a noob but how lean is too lean? And how far can we go? Thank you!
I know it might be a long article but once u click it please read it
until the end hahaha... my english is simple and direct (user friendly)
it wouldn make u fall asleep.. ^^
when dis happens my rev feels like a pull back, drop of performance for 1 sec,,,, on dyno machine at each run, it always happens at dat region, thus im not able to pull above dat region, as da a/f ratio fluctuates up...