Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="DoNuT" data-source="post: 437417" data-attributes="member: 40">hey bro, what problems were u having?[snapback]843573[/snapback][/b]</blockquote>was drifting at the pit corners and i think my left passenger tyres went into the ditch and hit the curb while drifting out from the apex. oh well it's okie lucky only nuts came broken not shockers hehehehe damn!!! or not i'll be playing all night long hehehehe[/QUOTE]

Verification

The Marketplace Latest

original rare Rays Volk Racing CE28 16x7jj offset...
- Started by david tao
- Chassis and Wheels
Honda Jazz/Fit JSracing GTwing Spoiler
- Started by jeff6126
- Exterior and Body
Toyota Vios NCP93 front bonnet hood
- Started by jeff6126
- Exterior and Body
Honda civic fc varis spoiler
- Started by jeff6126
- Exterior and Body
BMW F10 Msport front bumper set
- Started by jeff6126
- Exterior and Body
BMW F30 M3/GTS front bonnet hood
- Started by jeff6126
- Exterior and Body
BMW F10 vorsteiner rear bumper diffuser
- Started by jeff6126
- Exterior and Body
Mitsubishi Lancer Evo bodykit
- Started by jeff6126
- Exterior and Body
BMW F30 M3 front skirt lip
- Started by jeff6126
- Exterior and Body
Honda Civic FC fk7si front bumper set
- Started by jeff6126
- Exterior and Body

Posts refresh every 5 minutes

GAB Adjustable too soft... Need advise..

Dear Sifu's

My GAB adjustable current setting very very soft... soft bumpy not hard. [Hi / Lo] TYPE only not the [Hi / Lo Soft / Hard] TYPE.
Even used my...

Modified Car Competition & World Cup Screening @ Subang

Guys, there will be a Modified Car Competition & World Cup Screening at Jalan SS15/4 this Sun from 8pm onwards. Approximately 100 car parks will be reserved for this highly anticipated event. So far, a few teams have...

carbie car got speed sensor or not?

Hallo,
Need some advice, Im planning to install RSM Apexi.but my car running on carb engine so dont hv an ECU, So where should me connect RSM speed input? thanks...