How to Detail your Engine Bay (Basic)

vr2turbo

((( God Level 30,000 RPM )))
Helmet Clan
Moderator
May 11, 2010
30,001
8,385
1,713
Petaling Jaya
Uncle VR,

What precaution do you advice to take before cleaning engine bay of Kelisa? Is there any place that need to be covered?
If you are cleaning by chemical and rinse with water then basically electrical parts. Plugs, distributor, and especially those with ECU in engine compartment. ECU have to be covered properly, plugs and distributor can still wipe dry if water gets in, but not for ECU, but since kelisa ECU is in passenger compartment then it is safe.
 

Random Post Every 5 Minutes

hi to all,
i just got my Wira aeroback installed Tein S.TEC lower springs with GAB SA shocks (all are new unit). However, after installation, i found out my car's rear is higher than front (the car head is facing floor).

The difference is not very severe but can be seen quite easily on flat ground. Now my front wheel arc can put in 2 fingers, but rear can put in 4 fingers :banghead: the difference is about 3 cm.

So is this normal?? will it back to front-rear same height later?? or...
Ask a question, start a discussion or post something for sale!
Post thread

Online now

Enjoying Zerotohundred?

Log-in for an ad-less experience