tamiya mini 4wd

leynye yamin

Known Member
Senior Member
Sep 30, 2011
106
22
518
Sabah Sandakan
Hi, i have been researching methods to break in tamiya mini 4wd motor to produce higher rpm and power, anyone has any ideas? tried singer oil, lubricants etc. not yet try kerosene..

Recently researching on aa battery as well.. been eyeing on the Ni-Zn aa battery..
Looking to buy Lipo aa size 1.5v rechargeable battery..

Anyone has ideas? thx!
 

cvkit17

2,000 RPM
Senior Member
Mar 20, 2012
2,884
1,354
1,713
Kuala Lumpur
tamiya motor need to break in ? I dont think so because its not like a piston. The only part that have friction are the shaft and bearing..
 

vr2turbo

((( God Level 30,000 RPM )))
Helmet Clan
Moderator
May 11, 2010
30,001
8,385
1,713
Petaling Jaya
tamiya motor need to break in ? I dont think so because its not like a piston. The only part that have friction are the shaft and bearing..
Need to lightly oil it only. Oil too thick will slow it down.....:biggrin:
 

Random Post Every 5 Minutes

Hi guys, I'm a newbie here.. Previously loved to just watch comments & getting information from this site but i decided to register as a member here because i needed to look for an answer to the following questions.

I screwed up recently with my Myvi Extreme 1.5 Manual due to excessive work loads & judging from my current mileage from my due service which is in another 1.2k. The engine was totally dry of engine oil & as a result.. produced noises from the rods & bearing.

Went off to...
Ask a question, start a discussion or post something for sale!
Post thread

Online now

Enjoying Zerotohundred?

Log-in for an ad-less experience