extractor 4-1 and 4-2-1

malster

Active Member
Senior Member
Oct 26, 2008
32
0
1,506
hye...
anybody can tell me whats the different between this 2 extractor..
and which one is better for satria 1.3m
 

tiburonshrk

Known Member
Senior Member
Mar 6, 2006
52
0
1,506
4-2-1 are more intended for low revs and mid range. This helps during city driving or when u need just the right kick to overtake.

4-1 are designed for higher rpm range. I don't think this is appropriate as you don't usually rev ur engine that high most of the time.

Anyway, I don't think it is wise to change the extractor. A wrong design custom extractor will cause lots of problem to you such as loss of power. It is vital that an extractor measured and bent properly. If you still insist on changing, I would recommend hot bits extractor as I previously had on my satria and it was good.
 

malster

Active Member
Senior Member
Thread starter
Oct 26, 2008
32
0
1,506
where can i find those r3 or hot bits extractor
 

tiburonshrk

Known Member
Senior Member
Mar 6, 2006
52
0
1,506
For hot bits extractor, you can start with speedworks at jalan 222, PJ. They carry the whole range of hotbits products
 

malster

Active Member
Senior Member
Thread starter
Oct 26, 2008
32
0
1,506
any1 noe where can find extractor yg murah2 punya:biggrin:
 

afmarsyal

Known Member
Senior Member
Nov 20, 2008
100
6
1,518
wei yip wangsa maju atau seri kembangan..aku buat extractor kat diorang..4-2-1 downpipe swirl dalam rm280
 

malster

Active Member
Senior Member
Thread starter
Oct 26, 2008
32
0
1,506
ooo murah gak..
kat seri kembangan tuh kat area mane
 

tamok

Known Member
Senior Member
Aug 14, 2008
155
0
1,516
hallo guys
what about 4-4-1...lg power kot....cuma rege x leh tahan....
 

Random Post Every 5 Minutes

hi to all i'm using waja 1.8 changed to 4g93 ck2a enjin. i bought half cut for 8.5k ,bought spare parts ard 4k and labour charge and wiring charge 2.5k...after they finish pasang my enjin found out the problems oil pump is not functioning,so i went to half cut shop they said they were not warranty for this problem,shit i have to spend RM350 for an oil pump and overhaule the enjin cost me another 2k..blower not function and cooling coil gas leaking ,spend RM500, finally my car done , exhaust...
Ask a question, start a discussion or post something for sale!
Post thread

Online now

Enjoying Zerotohundred?

Log-in for an ad-less experience