Quote:
Originally Posted by nan83
hi ecupro,
still remember me, your protech1 user?? ( the green wira evo1 that come to yr house )
can you list down the spec of protech II & pro-se??
what's new in pro-se?? hope it can run on winxp....  |
"Emmmm....an old friend...."
Pro-SE, from the pics, is just home made ecu, re-design circuit board.
Basically, just a MS-Extra, it should run on winxp by using MS application program or tunning program.
Use back stock sensor and ignitor.
For this kind DIY, it only cost me :
A PCB ( design by me, but, have to drill a lot of hole )
A Home made programmer to program microcontroller
A microcontroller
A MAX-232 for communication with pc
A 37 pins mout pcb connector
Three Big transistor ( one for Mivec, two for injectors. Note : for low ohm injector, you have to use ballas, [a pack of low ohm resistor] )
Four small transistor ( two for ignitor [waste spark], one for fan relay and one for fuel pump relay )
So, the cost very very low, say Rm 150.00 ~ Rm 200.00
So far install on 4G61T, in and out for R & D.
For tunning, you can ask the MS Master,Cipan for help or give a CREDIT to him.
Thanks.... my old friend.( Are you the one from Petro...? )
