I was wondering anyone here can help with my little small project...
is a ek3 with B20B Vtec (b16 head small vtec oni)
the tranny shift fine and very smooth if drive normally ...
but when WOttttt ~~~ (pedal to metal) especially when transmission hot the rpm will reach 8.5k (which is rev limit) the gear hesitate to changes ... untill i release the pedal for few sec and reapply baru changes...
but i check the tranny fuild very nice ler... ( red and fresh ) lvl also cun... no leaking no funny noice..
my questions is shall i tighten the TV (throttle vavle) cable or loosen .. i look around internet i don't see any tutorial on this...
or any sifu can guide me ?
P/s yayayaya i know automatic suck.. sonner or later i will changes .. when buget allow
is a ek3 with B20B Vtec (b16 head small vtec oni)
the tranny shift fine and very smooth if drive normally ...
but when WOttttt ~~~ (pedal to metal) especially when transmission hot the rpm will reach 8.5k (which is rev limit) the gear hesitate to changes ... untill i release the pedal for few sec and reapply baru changes...
but i check the tranny fuild very nice ler... ( red and fresh ) lvl also cun... no leaking no funny noice..
my questions is shall i tighten the TV (throttle vavle) cable or loosen .. i look around internet i don't see any tutorial on this...
or any sifu can guide me ?
P/s yayayaya i know automatic suck.. sonner or later i will changes .. when buget allow