erm...I send my car to my friend accessory shop to take out the motor for service..after service mean clean the carbon and the koil. now my power window ok de. but the carbon going finish
I think the best is to look for a half-cut door at the junk yards. Probably cheaper than getting the original bit and waiting three monthsGUYS HELP! my Z's door (driver's side) can't open from the outside. something snapped inside apparently. and that part that needs to be replaced must be ordered from JAPAN and it'll take 3months?
Anyone with any solutions? pleaseeee
i got it...just let me know wat u wan...i send to u just in 1day....not 3months :)GUYS HELP! my Z's door (driver's side) can't open from the outside. something snapped inside apparently. and that part that needs to be replaced must be ordered from JAPAN and it'll take 3months?
Anyone with any solutions? pleaseeee
depend on condition.. sometime is the carbon dirt is make the motorerm...
u means tat if refill tat carbon so it can be use again?
where to find ta shop to do tis?
if long time din use(will caused dirty)...the carbon cannot contact. so after clean n wipe..it will functioning againdepend on condition.. sometime is the carbon dirt is make the motor
coin loss contact . after service the motor so far so good.. but my friend
just to inform me the carbon going finish..My friend place is near to KL Naza
acc. name M'sonik.. looking for Mr. Kenny 0122836556.. i hope can help you.
Thank you very much~^^depend on condition.. sometime is the carbon dirt is make the motor
coin loss contact . after service the motor so far so good.. but my friend
just to inform me the carbon going finish..My friend place is near to KL Naza
acc. name M'sonik.. looking for Mr. Kenny 0122836556.. i hope can help you.