- Jun 4, 2006
- 2,798
- 334
- 1,683
Thanks... Any other opinion??? Or experience??? I've heard bad n good results too... Just need more information.im think RM10 of Ron 97 can run around 35km to 45km depends on setting for street use also.
Thanks... Any other opinion??? Or experience??? I've heard bad n good results too... Just need more information.im think RM10 of Ron 97 can run around 35km to 45km depends on setting for street use also.
Thanks bro. I've talked to Jo last week. He say LT10s can instal O2 for close loop system. Can even instal innovate wideband for autotune.Depends on the tune la bro.... LT10s is unlike Haltech Sprint/Sport series can auto calibrate fuelling for up to 20% according to O2 feedback and airfuel ratio target. If the tune is good you'll get better mileage. All I can say is it would be far better compared to stock ECU since you have upgraded your engine. To invest in Microtech is a wise option.
Check connector. The 0-5V is giving full 5V signal. If cannot solve, the check the tps.dear all sifu,
what the impact if the tps reading at microtech handset showed 99%, this reading I get when on the ignition, not start the engine yet..not even press the throttle yet..
I tried to adjust the limit 99% , still cannot get the reading 0% .. does my tps sensor spoil ?
have u adjusted the tps sir?anyone could help me on this matter? anyone could offer or have any fren can recommended come and verify this matter? my area is in Cheras bandar Sri permaisuri..
thankz bro...power supply to the pump isnt controlled by the ecu sir, its controlled by the relay. go ahead and add another relay for dat peace of mind..
Everytime you remove the TPS you will have to recalibrate it. Assuming that you have calibrated the TPS and it won't show 0%. I am guessing that you have wired your TPS wire incorrectly or TPS sensor is kaputz.anyone could help me on this matter? anyone could offer or have any fren can recommended come and verify this matter? my area is in Cheras bandar Sri permaisuri..I cannot bring the car , because I take out the Throttle body ,I need to calibrate the TPS first before fit the TB.
kes guna modified manifold cam nie ler .. menyusahkan org..
Here the video result
YouTube - 22032010015.mp4
, it showed 99% even not press the throttle. ( engine not start)
does this could be the issues ??