paging for aftermarket pistons & rings expert in MY?

Discussion in 'Forced Induction & Engine Management' started by HKS-GT2835R, Jun 9, 2013.

  1. HKS-GT2835R

    HKS-GT2835R Senior Member
    Senior Member

    Joined:
    Apr 25, 2004
    Messages:
    1,193
    Likes Received:
    83
    guys.

    specifically, i have a re-bored block with a set of 4 fitting JE pistons & rings to go with it. the rings, however, requires precision gapping & cutting to be performed on them.the thought of using a grinder scares me, and after reading the instructions (typical US,all measurement is in inches) i already confuse myself.

    so in short, i nid some piston gapping done correctly to spec.
    is there any place that can do it in malaysia for a fee?

    thanks
     
    #1 HKS-GT2835R, Jun 9, 2013
    Last edited: Jun 9, 2013
  2. ^pomen_GTR^

    ^pomen_GTR^ Senior Member
    Senior Member

    Joined:
    May 13, 2010
    Messages:
    7,510
    Likes Received:
    1,688
    for free???

    good luck in that.....



    but to perform piston gapping atleast u should have the "fine" grade bench grinding stone..(including the machine)


    and with check twice/trice with the bore using feeler gauge
     
  3. HKS-GT2835R

    HKS-GT2835R Senior Member
    Senior Member

    Joined:
    Apr 25, 2004
    Messages:
    1,193
    Likes Received:
    83

    ....for a FEE . i'll be paying :thefinger:
     
  4. ^pomen_GTR^

    ^pomen_GTR^ Senior Member
    Senior Member

    Joined:
    May 13, 2010
    Messages:
    7,510
    Likes Received:
    1,688
    haha...my eyes playing trick....


    try ask milennium motorsports....

    or trial tuning shop
     

Share This Page