k20/24/DC5/FD2/EP3/CL9 hyper single clutch

Discussion in 'Engine and Performance' started by dcloo, Oct 6, 2009.

Thread Status:
Not open for further replies.
  1. dcloo

    dcloo Senior Member
    Senior Member

    Joined:
    May 11, 2005
    Messages:
    1,784
    Likes Received:
    17
    Exedy Hyper single For k20/24/DC5/FD2/EP3/CL9
    RM SOLD
    clutch pad left about 70% or 4.5mm thick not sure how for new one
    no burn mark on flywheel

    call 012-2123802

    SOLD
     
    #1 dcloo, Oct 6, 2009
    Last edited: Nov 3, 2009
  2. dcloo

    dcloo Senior Member
    Senior Member

    Joined:
    May 11, 2005
    Messages:
    1,784
    Likes Received:
    17
    BUmp.....
     
  3. dcloo

    dcloo Senior Member
    Senior Member

    Joined:
    May 11, 2005
    Messages:
    1,784
    Likes Received:
    17
    Mugen 4-2-1 Extractor for B16B/18C RM 1450
     
  4. limfk7

    limfk7 Senior Member
    Senior Member

    Joined:
    Feb 18, 2006
    Messages:
    211
    Likes Received:
    19
    the new clutch pad is 4.6mm so your clutch pad is about 96% new lo, trust me i used it too
     
  5. dcloo

    dcloo Senior Member
    Senior Member

    Joined:
    May 11, 2005
    Messages:
    1,784
    Likes Received:
    17
    i not sure how thick was the new clutch pad but the clutch was in very good condition

    3 item below condition as you see in pic
    EK 99 Front Bonnet,Rear Bonnet,Rear Bumper RM 1500
    Call 0122123802

    [​IMG]
     
Thread Status:
Not open for further replies.

Share This Page