im selling off 1 unit of IHI RHC6 turbo .....
the turbo was bought for RM1600.00
but now the turbo need to be serviced back so im selling it for RM 650.00 NEGO....
Location is in PJ or Bangsar ...
contact 017-6122855 (rajie)
The Spec of the turbo is as below
2.756" major diameter and 1.968" minor diameter on the compressor wheel
flow would be around 600-640CFM at 1.5bar -1.7bar , above that , higher than that can but the flow will be lower than max flow
600cfm - 640cfm is around 44-48lb/min
44lb/min will give 400hp
48lb/min will give 480hp
thats not on wheel , on dyno at 1.5-1.7bar u should get 350-420bhp
td06 20g max flows the same amount as this turbo also same goes with garrett 50trim t04e ar50 or ar60
the turbo was bought for RM1600.00
but now the turbo need to be serviced back so im selling it for RM 650.00 NEGO....
Location is in PJ or Bangsar ...
contact 017-6122855 (rajie)
The Spec of the turbo is as below
2.756" major diameter and 1.968" minor diameter on the compressor wheel
flow would be around 600-640CFM at 1.5bar -1.7bar , above that , higher than that can but the flow will be lower than max flow
600cfm - 640cfm is around 44-48lb/min
44lb/min will give 400hp
48lb/min will give 480hp
thats not on wheel , on dyno at 1.5-1.7bar u should get 350-420bhp
td06 20g max flows the same amount as this turbo also same goes with garrett 50trim t04e ar50 or ar60