Guys, yesterday i successfully installed EMU in my ride..it was though but worth it..., during the installation i notice that the speed signal that indicated by the Greddy installation manual is not there in my (5at ecu)...that is the only stumbling block that hits me yesterday...so currently without the speed signal tapping I'm unable to remove the speed cut..cheeeaah:stupid:...need help here if any of u guys know where to tap to remove the speed cut pls prompt me....bcoz from the toyota ECU trouble shooting guide there is a speed signal indicated at C23 but tapping it causing other unwanted problem.
hopefully the wideband thingy will be pass to me tomorrow...so i can start tuning it...tomorrow nite...after work
hopefully the wideband thingy will be pass to me tomorrow...so i can start tuning it...tomorrow nite...after work