[DIY] Free and Cool Gear Knob

[loose_end]

- Mask the table
- Mask the golf ball
- Clamp the golf ball tight

- Mark the center point

- Drill a hole according to the size and depth

- Remove the golf ball

- Stuff into your shifter [ Manual ]
- Done.

Golf ball was free as I stole it from my father* :P

 

[kumar22mostwanted]

woo ori NIKE gear knob but i think a bit slippery if hands are even slightly wet

 

[xtremeleo]

i use a snooker ball for the knob, cool jugek. blue no.2, nice one btw sir

 

[g4i8y0t]

wahh, so nice and creative! :top:

 

[Izso]

cool DIY dude! Does it pop out if excessive shifting is done? Or did you tape it down with some adhesive inside the hole?

 

[xtremeleo]

u can send the chosen knob to a machine shop and thread the hole, with the same thread size of ur shift lever, or else u need to sumbat the lubang kaw2 to keep it secured

 

[loose_end]

woo ori NIKE gear knob but i think a bit slippery if hands are even slightly wet

Yeah, Ori ball.. LoL.. I believe the dimples surface on the ball will give some grip

---------- Post added at 12:54 AM ---------- 6 hour anti-bump limit - Previous post was at 12:53 AM ----------

i use a snooker ball for the knob, cool jugek. blue no.2, nice one btw sir

Share some pictures bro ~

---------- Post added at 12:55 AM ---------- 6 hour anti-bump limit - Previous post was at 12:54 AM ----------

cool DIY dude! Does it pop out if excessive shifting is done? Or did you tape it down with some adhesive inside the hole?

I just stuff it in.. Will see how it goes

---------- Post added at 12:55 AM ---------- 6 hour anti-bump limit - Previous post was at 12:55 AM ----------

u can send the chosen knob to a machine shop and thread the hole, with the same thread size of ur shift lever, or else u need to sumbat the lubang kaw2 to keep it secured

It took me 10 minutes for this project only..

 

[har1th7]

i use a snooker ball for the knob, cool jugek. blue no.2, nice one btw sir

not too big? or maybe u have a bigger hand, sir....

 

[p3jal]

omg...how come u "tefikir" to do the golf ball as a gear knob.. very nice huhuhuh

 

[Veloc]

Lol like that also can think of it ah? And it looks nice

 

[Waiora_ProTuner]

Very cool..opened a whole new idea for custom gear knob..
any diy idea for auto knob?

 

[saifzwan]

huhuhu

 

[wiramax]

Kudos..:)

 

[ken yeang]

The golf ball idea has been around since VW Golf Gti MK1 (if not mistake) came about...

Google it to see...

Nevertheless, I always like the idea of DIY....

 

[Jai_RS]

Nice