[After12] Ultra Racing Genuine Products

Discussion in 'Chassis and Wheels' started by MAX_TorQue, Dec 2, 2008.

Thread Status:
Not open for further replies.
  1. MAX_TorQue

    MAX_TorQue Senior Member
    Senior Member

    Joined:
    Jan 18, 2006
    Messages:
    7,962
    Likes Received:
    20
    Intorducing Ultra Racing Performance Bars

    WHY Ultra Racing?
    During the development phase of Ultra Racing bars, we ensure the products are accordance to our design and development philosophy. We conduct real on-road performance test and well as on-track testing. In order to obtain data, we also invented three testing jigs, namely Bending Test Jig, Torsion Test and Flex Test Jig, to test the performance of our products as well as the competitors’.

    The strut bar is bolted to the jig to simulate the actual situation on the vehicle chassis. For torsion test jig, torque is applied to one side of the bar, and the amount of twist is recorded. Torque used was calculated and fixed at 6.6kg/m.

    For compression test jig, forces are applied along both sides of the bar. Maximum compression force is recorded to study the structure of various kind of designs that the bar can take under different kind of conditions or during an impact. We use a hydraulic pump to compress at set pressures and record the results

    For flex test jig, torques are applied on the ends of the bars to simulate the performance of the bar under chassis flex conditions. Torque used for the experiment is fixed at 8kg/m.

    [​IMG]


    Technical Information

    Strut Bars and Chassis Strengthening Technology

    If you're serious about your car's handling performance, you will first be looking at lowering the suspension. In most cases, unless you're a complete petrolhead, this will be more than adequate. However, if you are a keen driver, you will be able to get far better handling out of your car by fitting a couple of other accessories to it. The first thing you should look at is a strut brace. When you corner, the whole car's chassis is twisting slightly. In the front (and perhaps at the back, but not so often) the suspension pillars will be moving relative to each other because there's no direct physical link between them. They are connected via the car body, which can flex depending on its stiffness. A strut brace bolts across the top of the engine to the tops of the two suspension posts and makes that direct physical contact. The result is that the whole front suspension setup becomes a lot more rigid and there will be virtually no movement relative to each side. In effect, you're adding the fourth side to the open box created by the subframe and the two suspension pillars.

    Is there a need to have our vehicle chassis strengthened?

    The chassis of the car is the part which experiences the most of the abuse from the driver. It is particularly due to the weight transfer of the vehicle body during fast cornering, hard braking or hard acceleration. In some instances, the weight transfer during cornering may cause one side of the vehicle to experience as much as 3 times more force than the other side of the vehicle, causing enormous chassis flex/ vehicle body deformity and twist, consequently causing tires to lose grip. Deformity and twisting of the vehicle chassis during cornering may cause negative handling traits such as understeering and oversteering.

    For ORDER and ENQUIRY:
    Pls kindly SMS / PM for the model / bars that you are inetersted.
    WE will reply to you as soon as possible.

    -We provide installation as well.
    -Genuine Ultra Racing sticker and warranty card provided.

    By:
    AfterTwelve Motorsports
    -Authorised Ultra Racing dealer.
    -Lot 12, Jalan PJS 11/3, Bandar Sunway, 46510 P.J. Selangor.
    -Contact JACK 012.312.7113.
     

    Attached Files:

    • UR.jpg
      UR.jpg
      File size:
      11.6 KB
      Views:
      3,433
    #1 MAX_TorQue, Dec 2, 2008
    Last edited: Aug 6, 2010
  2. MAX_TorQue

    MAX_TorQue Senior Member
    Senior Member

    Joined:
    Jan 18, 2006
    Messages:
    7,962
    Likes Received:
    20
    We sell GENUINE products with FREE sticker and warranty card!!!
     
  3. xinghonh

    xinghonh Senior Member
    Senior Member

    Joined:
    Aug 25, 2006
    Messages:
    1,436
    Likes Received:
    7
    plz pm me price for
    room bar
    upper rear bar
    lower arm frnt n rear
    for satria gti
    thnx!
     
  4. CraZieThug5057

    CraZieThug5057 Senior Member
    Senior Member

    Joined:
    Dec 11, 2005
    Messages:
    759
    Likes Received:
    1
    HI there kindly quote me full kits of the ultra racing bars for my car nissan cefiro a31 i mean every bars and strengtening kits ....kindl quote me all the bes price ...

    reg
    George
    016-9278434
     
  5. BlueSamurai

    BlueSamurai Senior Member
    Senior Member

    Joined:
    Jun 21, 2006
    Messages:
    127
    Likes Received:
    6
    Hi need a quote on all Ultra Racing products for a Mitsubishi Lancer 1996.
     
  6. ToY_mAcHiNe5

    ToY_mAcHiNe5 5 Year | Silver

    Joined:
    Sep 1, 2008
    Messages:
    98
    Likes Received:
    3
    Hye there.. i`m looking for the UR bars for..

    Satria
    1. 4 point front under chasis bar
    2. 2 point room bar
    3. 3 point fender bar

    Kancil
    1. 4 point front upper bar
    2. 3 point fender bar
    3. 4 point rear bar ( under hood ) or any recommended for kancil..

    quote me the price for all 6 and postage to ipoh..
     
  7. Choon

    Choon Senior Member
    Senior Member

    Joined:
    Jan 4, 2005
    Messages:
    118
    Likes Received:
    0
    wat's the price for Wira 4-point front tower bar and lower arm bar?
     
  8. MAX_TorQue

    MAX_TorQue Senior Member
    Senior Member

    Joined:
    Jan 18, 2006
    Messages:
    7,962
    Likes Received:
    20
    Chech ur PM.
     
  9. MAX_TorQue

    MAX_TorQue Senior Member
    Senior Member

    Joined:
    Jan 18, 2006
    Messages:
    7,962
    Likes Received:
    20
    We sell GENUINE Ultra Racing products at PROMOTION price
    Free Sticker.
     
  10. xinghonh

    xinghonh Senior Member
    Senior Member

    Joined:
    Aug 25, 2006
    Messages:
    1,436
    Likes Received:
    7
    bro i tink u haven reply my pm yet :wavey:
     
  11. AXXeLL

    AXXeLL Senior Member
    Senior Member

    Joined:
    Nov 18, 2003
    Messages:
    1,591
    Likes Received:
    91
    bro, can get me price for Wira 1.5 rear anti roll bar... do u guys do installations?
     
  12. botakwong

    botakwong Senior Member
    Senior Member

    Joined:
    Dec 11, 2005
    Messages:
    25
    Likes Received:
    0
    Hey bro can quote me ARB for honda city. You have the old version bar?
     
  13. MAX_TorQue

    MAX_TorQue Senior Member
    Senior Member

    Joined:
    Jan 18, 2006
    Messages:
    7,962
    Likes Received:
    20
    Check ur PM.
     
  14. MAX_TorQue

    MAX_TorQue Senior Member
    Senior Member

    Joined:
    Jan 18, 2006
    Messages:
    7,962
    Likes Received:
    20
    Free Sticker!!!
     
  15. MAX_TorQue

    MAX_TorQue Senior Member
    Senior Member

    Joined:
    Jan 18, 2006
    Messages:
    7,962
    Likes Received:
    20
    Year end promotion!!!
     
  16. Choon

    Choon Senior Member
    Senior Member

    Joined:
    Jan 4, 2005
    Messages:
    118
    Likes Received:
    0
    jack rocks! just bought one from him.. gonna visit him again next tuesday..
     
  17. MAX_TorQue

    MAX_TorQue Senior Member
    Senior Member

    Joined:
    Jan 18, 2006
    Messages:
    7,962
    Likes Received:
    20
    Thanks bro!!!
     
  18. cidanz

    cidanz Senior Member
    Senior Member

    Joined:
    Nov 7, 2007
    Messages:
    13
    Likes Received:
    0
    pm me the best price with instalation for front bar 4 point n fender bar for satria 1.6..thns
     
  19. andrew lsp

    andrew lsp 15 Year | Platinum

    Joined:
    Mar 26, 2006
    Messages:
    86
    Likes Received:
    1
    bro rear anti roll bar 19mm for satria neo include installation price pm me pls tq
     
  20. MAX_TorQue

    MAX_TorQue Senior Member
    Senior Member

    Joined:
    Jan 18, 2006
    Messages:
    7,962
    Likes Received:
    20
    Check ur PM.
     
Thread Status:
Not open for further replies.

Share This Page